No Matches Found!
Try with a different search term
Having an issue where the Datalogic OEMConfig is not pushing out the changes to our fleet of Memor10 devices. The initial enrollment grabs all the settings and works fine. After the fact if I make and scanner symbology changes the settings never seem to get pushed out. Latest was a change to the Wedge settings and same thing, settings were never pushed out.
In the Applications tab after selecting the device in MobiControl, do a search for OEMConfig is listed as installed or uninstalled? I recently had a similar issue with M20 devices and I basically had to create a package to re-push OEMConfig apk before running settings again.
In the Applications tab after selecting the device in MobiControl, do a search for OEMConfig is listed as installed or uninstalled? I recently had a similar issue with M20 devices and I basically had to create a package to re-push OEMConfig apk before running settings again.
Shows installed. I went and changed a few settings on the gun as far as screen brightness, NTP and roaming strength and all the new settings were pushed out. I remembered I had done that before with success. But just changing symbology or wedge settings they never seem to go. Frustrating for sure.